(44) shall be increased where the lot is on the inside
of the curve or where the side lot lines converge
‘ £€rom the front to the rear, to ensure that the
minimum width at the required rear building line
de not less than the stated minimum parcel frontage
in width.
(c) In an RS-1 zone where a parcel of land to be subdivided
is occupied by an existing dwelling, the minimum frontage of one of the
lots to be created may be reduced by .20%, provided that:
(1) the overall frontage of the parcel. to be subdivided
is sufficient to produce the same number of lots
having frontages of not less than 15 m (49.2 sq.ft.) each if
the dwelling were to be removed as will be obtained by
taking advantage of this clause, and- ,
(44) the lot to which frontage exemption is granted
has a lot size of not less than 500 m2.(5,382 sq.ft.).

402. - Every parcel to be created shail abut a street.

403.° Notwithstanding Section 401 of this By~law, no parcel shail

be created which has an area less than that required by the Zoning By-

law.

404. Notwithstanding Se-tion 401 of this By~law, the Approving
Officer may refuse to authorize the creation of parcels meeting minimum
size requirements where in his opinion, by reason of topography, soil or
drainage conditions, .such minimum standards would injuriously affect the
established amenities of adjoining or adjacent properties or would be

against the public interest.

405. Where more than one use is intended for a parcel, the Approving .

Officer shall seiect the intended use with the greatest minimum area
requirements as determined in Section 401.

406. Parcels that abut a Strect at both front and rear shall not
be permitted unless, in the opinion of the Approving Officer such an
arrangement is essential

(a) to provide access tu other parcels,
{b) to provide a coherent arrangement of strecte,

(c) to complement a future pattern of subdivision.